Christoph Dobler - MATSim

More documents

Recommendations

Info

Configuration in config file via group multimodal• Parameter multiModalSimulationEnabled• Enable or disable the multi-modal simulation.• When enabled, in the Controler config group the parametermobsim has to be set to multimodalQSim.• Parameter numberOfThreads• If the value is > 1, a parallel implementation of the multimodalmobsim is used.• The parameter only affects the multi-modal part of thesimulation. The number of threads for the parallel QSim hasto be se separate!• Parameter simulatedModes• Defines which multi-modal modes are simulated.18
Configuration in config file via group multimodal• Parameters createMultiModalNetwork andcutoffValueForNonCarModes• simple approach to create a multi-modal network. All linkswith a maximum speed below the cutoff value become multimodallinks.• Parameter dropNonCarRoutes• Can be used to run a multi-modal simulation with non-multimodalinput plans.• Non-car routes are dropped and recreated when thesimulation is started (see PersonPrepareForSim).19
Page 1 and 2: Preferred Citation StyleDobler, C.
Page 3 and 4: Multi-modal simulations with MATSim
Page 5 and 6: Adding height information to a road
Page 7 and 8: Multi-modal travel times• Travel
Page 9 and 10: Pedestrian speed9
Page 11 and 12: Cyclists speed• Cyclists speed ca
Page 13 and 14: Cyclists speed13
Page 15 and 16: Implementation in MATSim• Multi-m
Page 17: Implementation in MATSim• Interfa
Page 21 and 22: Problems and to do’s• Performan

Christoph Dobler - MATSim

Create successful ePaper yourself

Delete template?

Save as template?