P556 Pistol new - Sig Sauer

“ejected” into the magazine area instead of outside the pistol.(Remember that the magazine should be removed prior tounloading the chamber.)2. Thoroughly clean the chamber and the extractor as often asnecessary to prevent accumulation of grease and dirt.3. If an empty magazine is in the pistol when the bolt is beinghand retracted to extract a cartridge, the cartridge may drop ontop of the magazine. Then, when the bolt goes forward, thecartridge will be chambered again! Always remove the magazinebefore clearing the chamber, and visually ensure that nocartridges remain in the pistol.TO CLEAR A MALFUNCTION (“JAM”)6.0. Procedures In Case Of MalfunctionShould the pistol fail to fire, perform the following actions:• Cycle the bolt; and• Continue firing.If the pistol does not fire after cycling the bolt:• Insert a fresh magazine;• Cycle the bolt; and• Continue firing.If the pistol still does not fire:• Put safety lever in the “S” (SAFE) position;• Remove magazine;• Lock the bolt to the rear;• Ensure the chamber is clear of all ammunition and foreignmatter (visual & physical check);• Turn gas valve on Position 2 when weapon is heavily fouled;• Insert fresh magazine;• Release bolt; and• Place safety lever in the “F” (FIRE) position, continue firing.P556 Pistol Operators Manual 38 1511582 VER 08.01.08