FURUNO FS-1570-2570 OPERATION.pdf - Yachtronics

6. MENU OPERATION6.11 Setting the AUTO ACK DetailsThe acknowledgement message may be sent automatically when you receive a messagewhich requires acknowledgement. You can also enable or disable it for position, polling andtest messages. Note that the automatic acknowledge is automatically disabled when RXcall contains error, as required by law. Further, automatic acknowledge is disabled in caseof OFF HOOK.1. Press the #/SETUP key.2. Choose USR SETUP, and push the ENTER knob.3. Rotate the ENTER knob to choose AUTO ACK, and push the ENTER knob.Default: ABLEUNABLEABLEEffective when 5/ACK/SQ key is set for "AUTO ACK."ABLE: Sends ABLE acknowledge automatically.UNABLE: Sends UNABLE acknowledge automatically.Note: Automatic acknowledge is automatically disabledwhen RX call contains error, as required by law.Further, automatic acknowledge is disabled in case ofOFF HOOK.Default: ONOFFON** Auto ack setup **COMPLY TYPE : ABLEUNABLE REASON :NO REASON GIVENPOSITION MESSAGE: OFFPOLLING MESSAGE: ONTEST MESSAGE: ONEffective when 5/ACK/SQ keyis set for "AUTO ACK."OFF: Disables automaticacknowledgement oftest call.ON: Enables automaticacknowledgement oftest call.Default: NO REASONNO REASONBUSYEQUIP DISABLEMODE NOT USABLECH NOT USABLESets reason for UNABLE.Note: This menu is the same as manualacknowledgement. EQUIPMENTDISABLE is shown in calls whenEQUIP DISABLE is selected.Default: OFFOFFONDefault: ONOFFONRotate ENTERknob to chooseEffective when 5/ACK/SQ keyis set for "AUTO ACK."OFF: Disables automaticacknowledgement ofposition request.ON: Enables automaticacknowledgement ofposition request.Effective when 5/ACK/SQ keyis set for "AUTO ACK."OFF: Disables automaticacknowledgement ofpolling request.ON: Enables automaticacknowledgement ofpolling request.6-18