Stage Boxes - Wenger Corporation

stacking stage BoxesStaCkING MethoDS1. When stacking Stage Boxes, always do one of the following:a. If stacking side to side or side to top surface, use the Fasteners to hold the Stage Boxesin place.b. If stacking the top surface to the bottom surface, insert the upper Stage Box Rubber Feet(on the bottom surface) into the Foot Pockets on the top surface of lower Stage Boxas shown below.Fastener1aSmallStage BoxMolded-inInsertLargeStage BoxStageBoxAlways insert the Rubber Feet on the upperStage Box into the Foot Pockets on the lowerStage Box when stacking Stage Boxes bottomsurface to top surface.1bStageBoxRubberFootRubberFootWhen stacking a Stage Box side surface to anotherStage Box, attach the two together with the Fasteners.FootPockets2. When stacking Stage Boxes, the bottom side of each Stage Box must be supported over thebox’s entire bottom surface area.Never create a bridge by attaching the Fasteners and not supporting the Stage Box fromthe bottom. The Fasteners will not support loading.Never create a bridge by attaching theFasteners and not supporting the Stage Boxfrom the bottom.The entire bottom surfacemust be supported whenstacking Stage Boxes.These two Stage Boxes areattached by the Fasteners! caUtionStage Boxes must always besupported at the bottom ona full side.! caUtionNever use the Stage BoxFasteners to support loading.Fasteners are intended onlyto hold Stage Boxes in place.! caUtionNever stand on Stage Boxesthat are stacked two or morehigh.5