13.07.2015 Views

Primepact 50 & 50LP RV Owner's Manual D7431 - Electric Generators

Primepact 50 & 50LP RV Owner's Manual D7431 - Electric Generators

Primepact 50 & 50LP RV Owner's Manual D7431 - Electric Generators

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

Section 3 – Post-installation Start-up AdjustmentsPRIMEPACT <strong>50</strong> Recreational Vehicle Generator3.5 INSTALLATION CHECKLIST◆LOCATION AND SUPPORT❑ Generator is properly located.❑ Generator is properly supported.❑ Generator is properly restrained.◆GENERATOR COMPARTMENT❑ Compartment construction is proper.❑ Holes/Openings are vapor-sealed.❑ Compartment size is correct.❑ Compartment is vapor-sealed.❑ Sound insulation is correct.❑ Floor cutouts are properly completed.◆COOLING AND VENTILATING AIR❑ Airflow is adequate.❑ Air inlet opening is correct.❑ Compensate for restrictions.❑ Check that installation has been tested.◆GASOLINE FUEL SYSTEM❑ Fuel tank complies with all applicable codes.❑ Fuel system is properly installed and checkedfor leaks.◆ OPTIONAL LP GAS FUEL SYSTEM❑ Fuel system is properly installed and checkedfor leaks.❑ Pressure at regulator inlet is correct.❑ Rated flow of primary regulator is correct.❑ All parts are properly installed.❑ Fuel system is properly tested/adjusted.◆EXHAUST SYSTEM❑ Exhaust system complies with all applicablecodes.❑ Exhaust system is properly and safely installed.◆ELECTRICAL CONNECTIONS❑ Connections comply with local code requirementsand all National <strong>Electric</strong>al Codes.❑ Junction box is properly installed.❑ Wiring meets all standards.❑ All connections are correct.❑ Conduit is properly installed and sealed.❑ Generator is properly bonded to the vehicle.◆BATTERY INSTALLATION❑ Recommended battery is installed.❑ Recommended cables are installed.❑ Cables are clean and tight.❑ Cables are connected properly.❑ Proper ventilation is provided.❑ Terminals are coated with anti-corrosion grease,and terminal covers are positioned.◆ OPTIONAL ACCESSORIES❑ Check that remote start/stop panels (if used) areinstalled properly.❑ Check that hourmeter kit (if used) is installedproperly.❑ Check that any other options and accessories (ifused) are installed properly.◆ POST INSTALLATION TESTS❑ Check that all tests are completed properly.DATE OF INSTALLATION ____________________________________________________NAME OF INSTALLER______________________________________________________SIGNATURE OF INSTALLER________________________________________________36 Generac ® Power Systems, Inc.

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!