DISTRIBUTED LOGIC CORPORATION

The controller will perform write checks if the default is taken.CHECK ALL WRITES AT HOST BY READING (L) Y? < CR >The diagnostic will NOT issue read commands to check the data just written if the default is taken.Otherwise, the diagnostic sorrvVare wili perform the write check function.USER DEFINED DATA PATTERN (L) N? The data pattern used in the diagnostic is worst case. To ensure prompt testing, always use thedefault value.SELECT PREDEFiNED DATA PATTERN '(0 FOR SEQUENTIAL SELECTION) (D) 0: < CR >Always use the default value.The test will begin after the hardware and ~oftware questions are answered.INIT SUBTEST STARTABOUT TO VERIFY VECTOR 154(0) FOR DEVICE 172150(0) ... COMPLETEDThe diagnostic will run until the transfer limit is reached. After the limit has been reached, thediagnostic will print status information about the unit under test and display the END OF PASS:CZRCD EOP 1o TOTAL ERRORSPage 28