Workshop Manual

General informationAbout the workshop manualThis workshop manual contains technical data for thestandard versions of engines TAMD63L-A,TAMD63P-A, TAMD74A-A, TAMD74A-B,TAMD74C-A, TAMD74L-A, TAMD74P-A,TAMD74C-B, TAMD74L-B, TAMD74P-B andTAMD75P-A.The engine designation and number are noted on thenumber plate. The engine designation and numbermust always be given in all correspondence about anengine.The workshop manual has been primarily preparedfor Volvo Penta service workshops and their qualifiedpersonnel. This assumes that people who use theManual have basic knowledge of marine drive systemsand can do the tasks of a mechanical or electricalnature associated with the trade.Volvo Penta constantly improves its products, so wereserve the right to make modifications without priornotification. All information in this manual is based onproduct data which was available up to the date onwhich the manual was printed. Any material changesintroduced into the product or service methods afterthis date are notified by means of Service Bulletins.Spare partsSpare parts for electrical and fuel systems are subjectto various national safety requirements such as theUS Coast Guard Safety Regulations. Volvo PentaOriginal Spares comply with these requirements. Nodamage whatever, occasioned by use of non-originalVolvo Penta spares for the product, will be compensatedby the warranty offered by Volvo Penta.Certified enginesWhen service or repairs are done to an exhaustemission certified engine, it is important to beaware of the following:Certification means that an engine type has beenchecked and approved by the relevant authority. Theengine manufacturer guarantees that all enginesmade of the same type are equivalent to the certifiedengine.This put special demands on service and repairwork, as follows:●●●●●Maintenance and service intervals recommendedby Volvo Penta must be complied with.Only Volvo Penta original spares may be used.Service to injection pumps, pump settings and injectorsmust always be done by an authorizedVolvo Penta workshop.The engine must not be converted or modified,except for the accessories and service kits whichVolvo Penta has approved for the engine.Installation changes to the exhaust pipe and engineair inlet ducts must not be done.● No seals may be broken by unauthorized personnel.The general advice in the operator's manual aboutoperation, care and maintenance apply.IMPORTANT! Delayed or inferior care/maintenance,and the use of non-original spares,mean that AB Volvo Penta can no longer be responsiblefor guaranteeing that the engine complieswith the certified version.Damage, injury and/or costs which arise fromthis will not be compensated by Volvo Penta.5