201 TS Operating Manual THERMAL ARC - Victor Technologies

TABLE OF CONTENTSSECTION 1:ARC WELDING SAFETY INSTRUCTIONS AND WARNINGS...................................... 1-11.01 Arc Welding Hazards........................................................................................ 1-11.02 Principal Safety Standards............................................................................... 1-51.03 Declaration Of Conformity............................................................................... 1-6SECTION 2:INTRODUCTION ...................................................................................... 2-12.01 How to Use This Manual.................................................................................. 2-12.02 Equipment Identification.................................................................................. 2-12.03 Receipt of Equipment....................................................................................... 2-12.04 Transportation Methods................................................................................... 2-12.05 Symbol Chart................................................................................................... 2-22.06 Description...................................................................................................... 2-32.07 User Responsibility.......................................................................................... 2-32.08 Duty Cycle........................................................................................................ 2-42.09 Specifications.................................................................................................. 2-5SECTION 3:INSTALLATION, OPERATION AND SETUP......................................................... 3-13.01 Environment.................................................................................................... 3-13.02 Location........................................................................................................... 3-13.03 Electrical Input Connections............................................................................ 3-13.04 Electromagnetic Compatibility......................................................................... 3-33.05 Setup for Welding............................................................................................ 3-43.06 STICK (MMA) Setup........................................................................................ 3-53.07 LIFT TIG / HF TIG (GTAW) Setup...................................................................... 3-73.08 Leak Testing the System.................................................................................. 3-83.09 When You Finish Using the Regulator.............................................................. 3-83.10 Storage of the Regulator.................................................................................. 3-8