Height 160mm, rm = running meter - Rekord Holzmann

Roller shutter boxesRoller shutter boxes Thermo Kfor buildings with clinkersXPS with general buildingsupervisory board appro-completely made of high performance insulation material XPS.val DIBT: Z-23.33-1264.prepared for use in clinker buildings. Cut to length. With head piece and claw and2 each 8mm bolts with locking nut for beam support fixing. Aluminum made innerand outer rail. Belt hole with brush sealing according to EnEV.275295340505050Dimensions and Measurement results:Research institute for heat protection.300300300505050Type Roller shutter box Thermo-K 28 Thermo-K 30 Thermo-K 34Height 300mm 300mm 300mmWidth 275mm 295mm 340mmInner side plate 50mm 50mm 50mmOuter side plate – – –Insulation to ceiling 50mm 50mm 50mmBale room 220mm 220mm 220mmR = m 2 K/W 1.15 1.07 1.07U = W/(m 2 K) 0.76 0.81 0.81f RSILintel 0.91 0.91 0.91Price 3/running meter 43.40 3 43.65 3 45.10 3Price head piece- and support insulation according to EnEV 7.50 3/roller shutter box 7.50 3/roller shutter box 7.50 3/roller shutter box90Passed tests /compliance with requirement Thermo-K 28 Thermo-K 30 Thermo-K 34Specialist group of roller shutter box suppliers ✔ ✔ ✔Minimum heat protection ✔ ✔ ✔Construction rules list A. Part 1. Version 2004/01 ✔ ✔ ✔Leaflet DIN 4108-2* ✔ ✔ ✔Construction rules list A. Part 1. Version 2004/01 ✔ ✔ ✔*in combination with closing cover system according to manufacturer's informationTotal length 135cm2 12 5101 cm 5 8 2111 cm101 cm• with energy savings quality label – EnEV –• easy to plaster due to PIR surface• quality by extruded polystyrene• approved by the building supervisory board no. Z-23.33-234• XPS as perimeter insulation approved under Z-23.33-1 264• no water intrusion, damp resistant• tested and monitored quality by research institute forheat protection• please observe plaster regulations:– DIN 18550 part 1: Plaster works – terms and requirements– DIN 18550 part 2: Plaster works – plaster of mortar withmineral binding agents, type• for coating with plaster material and/or tiles the systemrequirements of the respective mortar supplier apply• alternative mineral coating (concrete contact)• 30 years of durability guaranteed• construction length up to 6m.For determination of the length of the roller shutter boxThermo U following rules should be observed: Back masonryplus 24cm! That means the roller shutter box is supported by14cm at the belt side and on the opposite side by 10cm.At double sided belts or electro drive system it is 14cm each.In these dimensions the head piece insulation according toEnEV is included.More detailed information about roller shutter boxes. All prices plus VAT.Installation situation in the case ofmasonry 17.5cm wide, + 12cm insulationfor low energy construction style.