HOMMEL INCOLINE Dynamic systems for the measurement of ...

More documents

Recommendations

Info

MULTI-INCOMETERForm measuring system for crank- and camshaft bearingsMeasurement and analysis of• roundness• form• alignmentof parallel bores andbearings in developmentand production areasRoundnessStraightnessCylindricityParallelismInner diameterConcentricityMULTI-INCOMETER by HOMMEL INCOTECQuick and reliable documentationof roundness, form and alignment ofparallel bores and bearings in developmentand production areas.Economical measurementUnlike conventional form measurementmachines, the size of this machine isnot determined by the object to bemeasured. Thanks to the design of theMULTI-INCOMETER with exchangeablemeasuring heads and/or measuringshafts, simple adaptation of the probeto different engine block dimensionsis made possible. The simultaneousmeasurement of up to eight measuringlocations allow for shortened measuringtimes. The software activates appropriatecontrol and evaluation programs,eliminating time consuming programming.The results are available immediatelyafter the measurement, thereforeenabling quick, on-site analysis.MULTI-INCOMETERProbe M-750 with electronics10
MULTI-INCOMETERHigh flexibilityDue to the modular design withexchangeable measuring shafts andadjustable measuring heads varioustypes of objects can be inspected(i.e. crankshaft and camshaft bearings,gear boxes, etc.).Simple operation and handlingThe probe is inserted into the nearingline, mounted on the drive side and theshaft end and fixed within the object tobe measured. This installation is donewith simple, appropriately adaptedflanges. These flanges are pre-alignedand fixed to the object with a centeringunit before the probe is inserted. Forproduction areas where different measurementsare frequently taken, fixturesare used which do not require pre-centering.This makes it possible to start ameasurement immediately after insertingthe probe. Through use of the functionkeys, the connected computer andthe clear menu-guided software, theMULTI-INCOMETER measuring systemcan be operated without extensive training.Mobile useThe MULTI-INCOMETER system is quicklyready for use and measurement. It isespecially well-suited for on-site measurementsbecause of its small dimensionsand portability. This makes theMULTI-INCOMETER very practical for usein different areas such as development,laboratory, inspection and also in production.Measurement of crankshaft bearingsFixture for cylinder headMounting device for thecrankshaft bearing line.Measurement directly afterinserting the probe intothe engine block withoutpre-alignment11
Page 1: Precision is our business.HOMMEL IN
Page 6 and 7: V-INCOMETERSoftware options for res
Page 8 and 9: P-INCOMETERQuick measurement of for
Page 13 and 14: MULTI-INCOMETERIsometric display of
Page 15 and 16: MINI-INCOMETERForm measuring system
Page 17 and 18: TOPOMETERWide range of functionsThe
Page 19 and 20: SAMAutomatic measuring sequenceAfte
Page 21 and 22: VMMVALVE guide / seat measuring sta
Page 23 and 24: INCOWINDynamic measurementThe Windo
Page 25 and 26: TECHNICAL DATAProduct rangeDimensio
Page 27 and 28: TECHNICAL DATAVMMValve guide diamet

HOMMEL INCOLINE Dynamic systems for the measurement of ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?