Premier SD40-2 Diesel Engine - MTH Trains

Cab ChatterSometimes the Cab Chatter soundsdon’t play.Lock-outI can’t get the engine to run after Ipower up the transformer. It sits stillwith the engine sounds running.The engine won’t lock into forward,neutral, or reverse.VolumeThe sounds seem distorted, especiallywhen the whistle or bell is activated.RemedyCab Chatter plays only in neutral atrandom intervals.RemedyThe engine is locked into the neutralposition. Follow the procedure in the“Lock into a Direction” section.Engine speed must be below 10 scalemph (approx. 10 volts or less inconventional mode).RemedyProto-Sound 2.0 volume is set toohigh. Turn the volume control knob onthe bottom of the chassis counterclockwiseto reduce the volume.BatteryThe engine will not leave the initialneutral setting.I get no sounds when the engine shiftsbetween directions.RemedyCheck to be sure the battery isinstalled and fully charged. See the“Self-Charging Battery Back-Up”section.The battery may be dead or need tobe charged. See the “Self-ChargingBattery Back-Up” section.After I turn off my transformer, myengine continues to make soundsbefore quitting.FYSThe FYS sounds occasionally repeatthemselves.Proto-Sound 2.0 is designed tocontinue to sound for a few secondsafter power to the track has been shutoff.RemedyProto-Sound 2.0 has a built-in randomnumber generator that randomlyselects each sound clip to play.Because there are a limited number ofsound clips available in each FYSsequence, it is probable that some ofthese sound clips will be repeatedfrom time to time.Premier SD40-2 Diesel Engine 19