Operating Instructions GEORG FISCHER +GF+ ... - Orbitechnik.com

More documents

Recommendations

Info

5 Commissioning 5.1 Checking the scope of delivery Check all parts of the delivery for completeness and transport damage. Please report missing parts or transport damage to the support immediately. Normal accessories (subject to change without notice) º 1 saw blade º 1 ring spanner, 22 mm º 1 brush º 2 hexagon Allen keys º 1 tube of saw blade lubricant º 1 quick mounting base plate º 1 tube of special gear oil 8 GEORG FISCHER +GF+¹
5.2 Transporting and assembling the pipe cutter Transport Disconnect from the power supply before transporting, mounting or dismounting and allow the machine to run a stop. Mounting the quick mounting base plate The pipe cutter with the vise is mounted either º on the quick mounting base plate, or º on the quick mounting base plate (special accessory) with clamps. GEORG FISCHER +GF+ 1 �Mark and punch the bolt holes on the work bench. Use the quickmounting baseplate as a template. �Drill 13 mm Ø holes. �Bolt down the quick-mounting baseplate. �Place the vise with flanged-on pipe cutter on the base plate. Tighten the hexagon nut (1). 9
Page 1 and 2: Operating Instructions Code 790 044
Page 3 and 4: Table of Contents GEORG FISCHER +GF
Page 5 and 6: 0 About these operating instruction
Page 7 and 8: Working with safety in mind "Make y
Page 9 and 10: 3 Features and scope of application
Page 11: 4 Technical specifications Manufact
Page 15 and 16: Fitting the saw blade 5 Fitting the
Page 17 and 18: 6.3 Adjusting the additional cutter
Page 19 and 20: GEORG FISCHER +GF+ �Tighten the c
Page 21 and 22: 1 2 11/2 11/4 2 For non-stop operat
Page 23 and 24: 1 2 11/2 11/4 For non-stop operatio
Page 25 and 26: Interval after the first 150 hours
Page 27 and 28: Service / after-sales service Spare

Operating Instructions GEORG FISCHER +GF+ ... - Orbitechnik.com

Create successful ePaper yourself

Delete template?

Save as template?