Assembly instructions “SideWinder Roller Banners” - UK Exhibition

Photographs for easy identificationWebsite: www.UKExhibition.co.ukEmail: info@ukexhibition.co.ukTel: 0845 1080047Attaching the graphics to the Sidewinder Roller BannerAttach top rear of graphic panel to doublesided tape on top hanger.Attach front bottom edge of graphic panel todouble sided tape on leader sheet, asshown.Holding onto graphic, remove locking pin andallow graphic to slowly retract into unit.Attach End-TrimsTensioning the graphicInsert a standard screwdriver into the slot located at the end of the trim and turn clockwise to add tension to the graphicRemoving the tension:Insert a standard screwdriver into the slot and push to disengage the ratchet, hold in and turn anti-clockwise until tension inspring is released.To remove the graphic:Once tension has been released, carefully peel the graphic off the leader sheet, the graphic hanger can also be removed, repeatfor adding fresh graphicsImportant:To ensure a strong bond to the graphic and the double sided tape, we at UK Exhibition always add a further tape on the rearsection, this we advice our customers to do if they are attaching the graphics them selves