Installation Instructions F2260V - Cal-Royal

1. MARK VERTICAL AND HORIZONTALREFERENCE LINE ON DOORDETERMINE BACKSET TO LOCATE VERTICAL REFERENCE LINE1. IF LOCK STILE IS 4-1/2” WIDE OR WIDER, BACKSET IS 2-3/4”2. IF LOCK STILE IS LESS THAN 4-1/2” WIDE, BACKSET IS HALF OFTHE EXPOSED WIDTH OF LOCK STILE.4. ATTACH TOP AND BOTTOM CHASSISADJ PINTOP RODTOP RODGUIDEMAIN SLIDEPULLMAN LATCHTOP CHASSIS(2) NO. 12 FLAT HEAD SCREWSASSEMBLYRETRACTORTOP RODLIFT ARMTOP STRIKE1/8” GAPREQUIREDNOTE: SHIM TOP STRIKE WHENNECESSARY TO OBTAIN 1/8” GAPTOP SLIDEDOWN1. MOUNT TOP STRIKE PER LOCATION IN2ND STEP.2. SCREW TOP ROD INTO MAIN SLIDE.3. SLIDE GUIDE AND COVER ON TO TOP RODAND ASSEMBLE CHASSIS BY INSERTINGADJ PIN THRU RETRACTOR AND MIDDLEHOLE IN ROD. (SEE FIG AT LEFT)ADJ TOP CHASSIS MOUNTING HOLES LINEUP WITH LOCATION MARKED IN 2ND STEP.4. MOUNT BOTTOM CHASSIS SAME WAY AS TOCHASSIS (SEE FIG AT RIGHT)5. AS TO BOTTOM STRIKE APPLICATIONVARIATIONS, PLEASE REFER TO FIGBELOW FOR THE CORRECT MARRIAGE. ADJ PIN6. FASTEN GUIDE.RETRACTORIF SHORTER ROD REQUIRED, CUT TOLENGTH AND DRILL 1/8” O HOLE THRU./MAIN SLIDEBOTTOM ROD GUIDEBOTTOM RODSTEEL BOTTOMCOVERBOTTOM RODBOTTOM BOLTCHASSIS ASSEMBLYREMOVABLE BOLT PINFOR ADDED ADJUSTMENTIF NECESSARYSPRING3/16”FLAT STRIKESTEEL SCREWS ANDMORTISE NUTS3/16”SPRINGSTRIKE TRESHOLD2. PREPARE DOOR5. APPLY RAIL ASSEMBLYVERTICALCHASSISFOR DOOR WITH STILECUT OFF MUST LEAVE 1/2” MINOVERLAP WIITH RAILCUT OFF AND DEBURR1-3/4” MINDON’T CUT CLOSER THAN1-3/4” FROM LOWER PIVOT3. APPLY TRIM+CHASSISLEVELRAIL ASSEMBLYATTACH TO CHASSIS WITH (2)#6-32X3/8” PHILIPS TRUSSHEAD MACHINE SCREWS6. APPLY COVERMOUNTING PLATE SCREWSTIGHT AGAINST RAILATTACH MOUNTING PLATE TO DOORWITH (3) ROUND HEAD SCREWS

F2260