21.07.2015 Views

Magiglo Duo Power side vent trim switch fitting ... - The Fire Basket

Magiglo Duo Power side vent trim switch fitting ... - The Fire Basket

Magiglo Duo Power side vent trim switch fitting ... - The Fire Basket

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

<strong>Duo</strong> <strong>Power</strong> SV Trim SwitchInstallation SupplementModels:SV – Side and Top VentingTo be used in conjunction withDUO POWER SV main appliance instructionsFor use on Natural Gas (G20) at a supply pressure of 20mbaror Propane (G31) at a supply pressure of 37mbar in GB and IE(Dependent upon model)Users,Installation & ServicingInstructionsMUST BE LEFT WITH THE USER


Manufacturer Contact Details:Burley <strong>Magiglo</strong>Lands End WayOakham, Rutland, LE15 6RBTel: +44 (0)1572 725570Fax: +44 (0)1572 724390General E-Mail: info@magiglo.co.ukWeb Site: www.magiglo.co.ukTechnical Support: Direct Dial on (01572) 725570 or email: technical@magiglo.co.ukBurley <strong>Magiglo</strong> Document Number:BMF271.21Revision Date:23 September 2009Copyright:This documentation is copyrighted by Burley <strong>Magiglo</strong>. ©2009.No part of this document may be copied, photocopied or reproduced in any form or by anymeans without permission in writing from Burley <strong>Magiglo</strong>.<strong>Magiglo</strong> is a registered trademark of Burley Appliances Ltd.


Contents1. USER INSTRUCTIONS .......................................................................................................... 11.1. Lighting <strong>The</strong> Main Burner (Trim Switch Control) ..................................................... 12. INSTALLATION INSTRUCTIONS .......................................................................................... 32.1. General Dimensions................................................................................................ 32.2. Technical Data ........................................................................................................ 32.3. Appliance Location .................................................................................................. 43. SERVICING INSTRUCTIONS................................................................................................. 53.1. Circuit Diagram ....................................................................................................... 53.2. Wiring in<strong>side</strong> Control Box ........................................................................................ 63.3. Wiring in<strong>side</strong> Trim Switch ........................................................................................ 6


This page is left intentionally blank


1. USER INSTRUCTIONS1.1. Lighting <strong>The</strong> Main Burner (Trim Switch Control)1. Turn the control knob fully anti-clockwise tothe (Large Flame) position (Figure 1).2. Set the High/Low <strong>switch</strong> on the <strong>trim</strong> to the(Large Flame) position (Figure 2).3. To turn the fire down to a low rate, push theHigh/Low <strong>switch</strong> on the <strong>side</strong> of the SmallFlame picture.Figure 1 - Maximum Position4. To turn the main burner off, press theOn/Off <strong>switch</strong> at the O <strong>side</strong>.5. Turning the Control knob fully clockwise tothe OFF position will turn off the pilot.NOTE: <strong>The</strong> main burner will notlight unless the fan is <strong>switch</strong>edon.BRASSTRIMFigure 2 - <strong>Duo</strong> <strong>Power</strong> Fan Control (Side Trim)Page 1


Page 2This page is left intentionally blank


Hearth2.3. Appliance Location<strong>The</strong> fire must be fitted on a flat noncombustiblehearth. In addition, a noncombustiblehearth with minimum dimensionsas shown in Figure 4 must be provided in frontof the fireplace opening.A suitable proprietary fire surround with aminimum of 150 o C rating may be fitted in frontof the fireplace opening.A<strong>Fire</strong>Surround150mm 150mm50mm min(or 12mm witha fixed fender)Figure 4Dimension ATrim Switch ControlTable 2330mm minPage 4


3. SERVICING INSTRUCTIONSNOTE: <strong>The</strong> Trim Switch Model has a Twin Solenoid rather than the standardsingle solenoid.3.1. Circuit DiagramFigure 5 – Circuit Diagram (Trim Switch Control Models)Page 5


3.2. Wiring in<strong>side</strong> Control Boxg/y g/yg/yTOTRIMSWITCHESbrblblblbrbrblblbrbkbrbl87654321bkblbrbrblbkwrrg/yPOWERSUPPLYTO FANBOXCOLOUR CODINGbk - blackbl - bluebr - brownr - redw - whiteg/y - green/yellowVeristorNEONFigure 6 - Wiring in<strong>side</strong> Control Box (Trim Switch Control Models)3.3. Wiring in<strong>side</strong> Trim SwitchFigure 7Page 6


This page is intentionally left blankPage 7


Burley <strong>Magiglo</strong> fires are protected byUK patents 2193802, 2240620 and 2256920Other Patents Pending<strong>Magiglo</strong> is a registered trademark of Burley Appliances Ltd.Burley <strong>Magiglo</strong>, Lands End WayOakham, Rutland, LE15 6RBTel: 01572 725570 Fax: 01572 724390www.magiglo.co.uk Email: info@magiglo.co.ukBMF271.2

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!