backer

R10.04 Notes:1] Add EPS profile to flat foam using StoDispersion Adhesive applied with a 3/4" nappaint roller. Allow to dry.2] Install Sto base coat and detail mesh over theprofile lapping onto the face of the wall 3".3] Install Sto base coat and mesh to the face ofthe wall overlapping the profile andfeathering it out to a smooth finish.Sto Detail 10.04: Profile10.73 Notes:1] Terminate EIFS at location where electrical boxwill be installed. Leave 1/2" clearance for <strong>backer</strong>rod and sealant.2] Set the electrical box in a bed of sealant andsecure into place.3] Install closed-cell <strong>backer</strong> rod and low modulussealant between the EIFS backwrapping andthe electrical box.4] Install finish.5] Install fixtures (not illustrated) by fastening tothe electrical box. Set the tops and sides offixture in sealant but leave the bottom open.Sto Detail 10.73: Electrical Box forExterior LightingPage 3 of 6Sto Essence NExT ® Application Guide for Zaxby’sJune 2004