Daisy Outdoor Products Rogers AR 72757-0220 U.S.A 800-643-3458 www.daisy.com

SLING ATTACHMENTThe sling is attached by a detachable sling swivel which connects to a sling bracket on the forwardend of the accessory rail. With the sling attached to the swivel and then pulled back along theunderside of the rifle, the tab end of the sling should be hanging down (See Drawing No. 9A).NO. 9ASLING SWIVELNO. 9BSLINGSWIVELSLINGBRACKETRIFLE LOOPTAB ENDOF SLINGLENGTH ADJUSTING KEEPERARMLOOPPUTTING SLING ON ARM:1. Open the arm loop.2. Turn loop one quarter turn in the direction of the sling arm (i.e., one quarter turn to the left if thesling is going on the left arm) and slip your arm into the loop (See Drawing 9B).3. Place sling loop on your upper arm either above the biceps near the shoulder or below thebiceps.4. Tighten the sling loop until it is snug enough to remain in place on your arm. it should not be sotight that it restricts the flow of blood in your arm or creates a pulse effect.LENGTHENING SLING:Grasp the tab end of theNO. 9Ckeeper with your trigger handand lift it up while pulling onthe top strand (not the tabend) of the sling (See DrawingNo. 9C).SHORTENING SLING: Pullthe tab end of the sling awayfrom you until sling reachesthe desired length. (See Drawing 9D).STOCK ADJUSTMENTSTo adjust stock, loosen screws in buttplatesufficiently to allow insertion of the desired number ofspacers (See Drawing No. 10). Spacers go betweenstock and buttplate. Each insert will adjust stock length5/8 inch (.625 inch). After stock adjustment insertshave been added, tighten buttplate screws to lockinserts in place. To shorten the stock reverse thisprocedure. Be certain spacers are placed so themolded cleats nest in the molded receptacle.9SPACERBUTTPLATEBUTTPLATESCREWSNO. 10NO. 9DSTOCK