sitrans tk/tk-h

More documents

Recommendations

Info

Operating instructions 7NG312*--1JN01, 7NG312*--2JN01 4 Operation 4.1 Operation with a PC/Laptop 4.1.1 Operation with a PC/laptop when using SITRANS TK When using the SIPROM TK parameterisation software and the modem for SITRANS TK, the transmitter can be operated with a PC. To do this, simply connect the transmitter to the PC via the modem. In doing so, the power needed for the transmitter is supplied through the PC’s serial interface. For further details, please refer to the SIPROM TK instruction manual and, for details of the modem, refer to the SITRANS TK instruction manual. 4.1.2 Operation with a PC/laptop when using SITRANS TK-H When using the SIMATIC PDM parameterisation software and the interface for the transmitter can be operated and parameterised with a PC. To do this, the interface must be connected to the output circuit. To this end, the transmitter’s power supply must be in operation and the load in the circuit must be at least 230 Ohm. 4.2 Operation with a hand-held communicator Connect the hand-held communicator to the SITRANS TK-H (see Figure 7). Action keys With the key, you switch the hand-held communicator on and off. After switching on, the handheld communicator automatically assumes communication with the transmitter. The online menu appears in the display. With the key, you move the cursor up through the menu bar. The selected line of the menu is marked. With the key, you move the cursor down through the menu bar. The selected line of the menu is marked. With the key, you move the cursor to the right through the menu bar or you branch to a subroutine. The name of the selected subroutine is shown on the top edge of the display. With the key, you move the cursor to the left through the menu bar or you exit a subroutine. Function keys The function keys F1 to F4 are located under the LCD display. The functions of the keys, which differ from one menu to another, are shown on the bottom edge of the display. Alphanumeric and shift keys You can enter alphanumeric values by means of these keys. Whether a key functions as a number or letter key depends on the respective menu. Letters are selected by pressing the affiliated shift key beforehand. Please refer to the operation instructions of the HART communicator for all further information on operation and for the technical data. SITRANS TK/TK-H A5E00226012--01 37
7NG312*--1JN01, 7NG312*--2JN01 Operating instruction 5 Maintenance The transmitter requires no maintenance. 38 SITRANS TK/TK-H A5E00226012--01
Page 1 and 2: Operating Instructions Edition 05/2
Page 3 and 4: 7NG312*--1JN01, 7NG312*--2JN01 Oper
Page 17: 7NG312*--1JN01, 7NG312*--2JN01 Oper

sitrans tk/tk-h

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?