Cube Highchair

More documents

Recommendations

Info

4 Parts check list Figure 1 Important Notes Please take a few minutes to read this user guide. card any packaging until you are sure that you have all the parts. - Safety harness is not included. You should always use a saftey harness complying with BS6684:1989. www.obaby.co.uk
Assembly 5 Figure 2 Assemble the table and chair as shown in the diagram, using the tool “O”. (Please note: the chair side slats have been omitted for clarity). It may help if the bolts are not fully tightened until assembly is complete. Please note that the crotch strap must as a highchair, ensure that the table surface “H” is at the rear and that the rear chair legs are in front of the table rail “K” - refer to the diagram for guidance. Attach a safety harness (not included) to the metal rings at the rear of the right and the left chair frames “A” and “B”. www.obaby.co.uk
Page 1 and 2: Cube Highchair Instruction Manual I
Page 3: Safety Warnings 3 • Do not use th
Page 7 and 8: Fitting the tray 7 Figure 5 WARNING

Cube Highchair

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?