Rotary Saws

More documents

Recommendations

Info

Partner Adjustment Procedures The following procedure can be used to reposition the cutting arm (inboard/outboard), adjust the guard position and adjust belt tension on the Partner K-1200 <strong>Rotary</strong> Saw. 1. Remove the drive belt protective casings. 2. Loosen the retaining nuts for the cutter arm. 3. Insert the screwdriver end of the combination wrench in the slot provided on the eccentric and rotate it clockwise to relieve drive belt tension (see Figure 8).
Partner Adjustment Procedures 4. Remove the drive belt from the front pulley. 5. Remove the mounting bolts and rotate the cutter arm 180°. Reposition the cutter arm on the opposite side. 6. Replace the mounting bolts and fasten retaining nuts hand-tight. Insure eccentric is resting in line with spring tensioning rod 7. Slip the drive belt over front pulley.
Page 1 and 2: Rotary Saws
Page 3 and 4: Partner K 700 Active III • Displa
Page 5 and 6: SAFETY OPERATIONS The following saf
Page 7 and 8: SAFETY OPERATIONS • Particular ca
Page 9 and 10: USE OF BLADES Their uses include:
Page 11 and 12: Composition blades • There are tw
Page 13 and 14: Metal Cutting Blade • A compositi
Page 15 and 16: OPERATING TIPS To prevent the blade
Page 17 and 18: OPERATING TIPS • If used for vent
Page 19 and 20: MAINTENANCE INSTRUCTION Weekly Chec
Page 21 and 22: MAINTENANCE INSTRUCTION Monthly Che
Page 23 and 24: After Use 4. Check for loose or bar
Page 25 and 26: Mounting or Changing Blades 3. Blad
Page 27: Partner 4. Mount desired blade in p
Page 31 and 32: Starting and Stopping 1. Hold saw f
Page 33 and 34: TROUBLE SHOOTING Saw will not start
Page 35 and 36: TROUBLE SHOOTING Blade Binds While
Page 37 and 38: TROUBLE SHOOTING Rough Running 1. C

Rotary Saws

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?