Rotary Saws

More documents

Recommendations

Info

TROUBLE SHOOTING 5. Flooded cylinder (use procedures below): a. Place on/off switch in "off" position. b. Turn saw on its side (exhaust side down). c. Push in choke ("off" position). d. Pull starter rope, 4-5 times, to clear cylinder of fuel. e. Place switch in "on" position and use normal starting procedures.
TROUBLE SHOOTING Blade Binds While Cutting 1. Improper cutting technique. 2. Mechanical Problem a. Immediately discontinue cutting. b. Shut off saw. c. Check belt tension and adjust as necessary. d. Check blade retaining nut and tighten as necessary. e. If blade or belt does not turn, check condition of centrifugal clutch. If the saw rpms increase proportionally with the throttle and the belt and blade do not, the centrifugal clutch is. bad.
Page 1 and 2: Rotary Saws
Page 3 and 4: Partner K 700 Active III • Displa
Page 5 and 6: SAFETY OPERATIONS The following saf
Page 7 and 8: SAFETY OPERATIONS • Particular ca
Page 9 and 10: USE OF BLADES Their uses include:
Page 11 and 12: Composition blades • There are tw
Page 13 and 14: Metal Cutting Blade • A compositi
Page 15 and 16: OPERATING TIPS To prevent the blade
Page 17 and 18: OPERATING TIPS • If used for vent
Page 19 and 20: MAINTENANCE INSTRUCTION Weekly Chec
Page 21 and 22: MAINTENANCE INSTRUCTION Monthly Che
Page 23 and 24: After Use 4. Check for loose or bar
Page 25 and 26: Mounting or Changing Blades 3. Blad
Page 27 and 28: Partner 4. Mount desired blade in p
Page 29 and 30: Partner Adjustment Procedures 4. Re
Page 31 and 32: Starting and Stopping 1. Hold saw f
Page 33: TROUBLE SHOOTING Saw will not start
Page 37 and 38: TROUBLE SHOOTING Rough Running 1. C

Rotary Saws

Create successful ePaper yourself

Delete template?

Save as template?