Connect

More documents

Recommendations

Info

Building Process Wood Work Cutting the Metal L Sections and bars Making a Jig for the Welding Prepping the Metal for Welding Welding Assembling Research Initial Ideas Development Building Evaluation
Cutting the Metal L Sections and Bars Workshop Notes 16/01/15 .Cut all L-sections needed for bottom part .Made sure that bar and more L-sections were ordered .Got advice on how to prepare for welding: - Cut 45deg off one bit for each weld - Get rid of oxide layer on both pieces - Weld top and bottom seperately, then combine - Make sure all angles are correct by creating a rig where the beams are nailed to a surface. (Height is not important here, only width). Use this for top and bottom and four bits of 70x70 for combining the two parts. Research Initial Ideas Development Building Evaluation
Page 1 and 2: Space Frame Connect 1:1 K2
Page 3 and 4: Initial Model Building Overall Spac
Page 5 and 6: Renzo Piano - IBM Pavilion Research
Page 7 and 8: Concept - Finger joint Research Ini
Page 9 and 10: Research Initial Ideas Development
Page 11 and 12: Research Initial Ideas Development
Page 13 and 14: Manufacturing and Assembly Developm
Page 15: Research Initial Ideas Development
Page 19 and 20: Making a Jig for the Welding Using
Page 21 and 22: Assembling Research Initial Ideas D

Connect

Create successful ePaper yourself

Delete template?

Save as template?