Connect
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Cutting the Metal L<br />
Sections and Bars<br />
Workshop Notes<br />
16/01/15<br />
.Cut all L-sections needed for bottom part<br />
.Made sure that bar and more L-sections were ordered<br />
.Got advice on how to prepare for welding:<br />
- Cut 45deg off one bit for each weld<br />
- Get rid of oxide layer on both pieces<br />
- Weld top and bottom seperately, then combine<br />
- Make sure all angles are correct by creating a rig where the beams are nailed to a surface.<br />
(Height is not important here, only width). Use this for top and bottom and four bits of 70x70 for combining<br />
the two parts.<br />
Research Initial Ideas Development Building Evaluation
Change language