NEWHOLLAND T7030.40.50.60 Repair Mannual

DISTRIBUTION SYSTEMS ­ FAULT CODES
2338­Creeper potentiometer ­ short circuit to +8V or +12V
NOTE: When the cause of the error code has been rectified, clear the error code and test the system for normal
operation.
Cause:
Possible failure modes:
1. Faulty connector
2. Faulty creeper potentiometer
3. Faulty harness
4. Faulty controller
Solution:
1. Check the creeper position sensor connector C347 and the controller connector C127.
A. Ensure the connectors are connected, not damaged, the pins are in the correct position and that the fit is
tight. Repair or replace as required.
B. If the connectors are okay, continue to step 2
2. Check for +5 Volts.
A. Disconnect connector C347. Turn the keystart ON. Measure the voltage between connector C347 pin 1
(TN) and ground. If +5 Volts is not indicated, repair or replace the harness as required.
B. If +5 Volts is indicated, continue to step 3
3. Check for an open ground circuit.
A. Check between connector C347 pin 3 (B) and ground. If an open circuit is indicated, repair or replace the
harness as required.
B. If an open circuit is not indicated, continue to step 4
4. Check for a short to +Ve voltage.
A. Turn the keystart ON. Measure the voltage between connector C347 pin 2 (O/L/B) and ground. If a voltage
is indicated, repair or replace the harness as required.
B. If the harness is okay, remove and replace the creeper position sensor. If the fault is still present, download
the correct level of software. If the fault re­occurs, remove and replace the controller.
2 3/5/2007
A.50.A / 502