NEWHOLLAND T7030.40.50.60 Repair Mannual

DISTRIBUTION SYSTEMS ­ ELECTRONIC SYSTEM
The lower central display will display "ch _"
The required channel can be selected by using the “h" and “m" keys.
After a delay the current setting will be displayed. (see the table below for the description the channel).
BAIL06CCM446AVA 79
Channel
Ch 1
Engine power boost demonstration
Description
Channel 1 ­ Engine Power Boost Demonstration
Power boost will only be active under the following conditions:
• No PTO torque sensor or calibration fault codes
• PTO is fully engaged
• Wheel speed is greater than 0.5 Km/h.
• Engine speed is greater than 1300 rev/min.
• Coolant temperature is below 105 °C.
• PTO has at least 250 Nm torque applied
The lower central display will display “Pbd" (Power boost demonstration).
Start the engine and operate the vehicle to activate engine power boost. The power boost lamp on the ADIC will be
illuminated when power boost is enabled.
Engine power boost will work as normal, but using the CRPM adjustment switch will turn the powerboost on and off.
CRPM increase switch (1) to turn power boost ON
CRPM decrease switch (2) to turn power boost OFF
NOTE: Power boost demonstration will be disabled after turning the keystart OFF.
BAIL06CCM484AVA 80
2 3/5/2007
A.50.A / 123