User Guide Pulpmatic Uno V2.1
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Other Faults<br />
Symptom Possible Cause Action<br />
There are no<br />
lights on the<br />
machine<br />
No electrical power to<br />
the machine<br />
<br />
<br />
Check the local electrical switch is on<br />
Replace the fuse in the electrical outlet<br />
<br />
Check other electrical items in the area are live<br />
<br />
Check the circuit breaker in the fuse board<br />
<br />
Seek assistance from electrically competent person<br />
or call DDC Dolphin or an authorised support agent<br />
for assistance<br />
The chamber<br />
is not clear at<br />
the end of a<br />
cycle<br />
Too many items<br />
placed in chamber<br />
Or<br />
Non maceratable<br />
goods in chamber<br />
<br />
<br />
Run a cycle with no additional products<br />
Check all items placed in machine are maceratable<br />
Reduce load if multiple wipes or SAP are used<br />
The lid will<br />
open but will<br />
not run a<br />
cycle<br />
The water tank is not<br />
full<br />
<br />
<br />
If the green READY light is flashing, the water tank<br />
is not full<br />
Check you can hear the noise of running water.<br />
(The tank filling with water)<br />
<br />
If there is no running water check the local supply<br />
tap is turned off<br />
<br />
Seek the assistance of a competent maintenance<br />
person, DDC Dolphin or an authorised support<br />
agent for assistance<br />
<br />
Has machine been overloaded and pulp or other<br />
items remain in the cylinder<br />
<br />
Unplug the machine or remove the fuse from the<br />
isolator then clear pulp from chamber<br />
<br />
Check drains have not blocked, possibly indicated<br />
by a build-up of water in the chamber<br />
<br />
If necessary have drains cleared this will permit<br />
water to leave the chamber<br />
Copyright © 2015 DDC Dolphin Ltd. Page 31 of 36 December 15 UG-<strong>Uno</strong>-<strong>V2.1</strong>