Campbell 2016

Eye Nuts, Carbon Steel, Normalized, C-776-G
■■
Drop-Forged Carbon Steel Normalized
■■
Galvanized to Meet ASTM A-153 Specifications
■■
Design Factor: 5 to 1
■■
Do Not Exceed Working Load Limit (WLL). The Standard
WLL’s are established for a Vertical In-Line Pull
■■
Make Sure Eye Nuts are Properly Seated by Screwing them
Down Completely
■■
Make Sure the Threads in the Hole are Clean and Undamaged
■■
Loads Must Always be Applied Parallel to the Plane of the Eye
and Never Across the Plane
■■
Always Stand Clear of the Load and Lift the Load With a
Steady, Even Pull. Do Not Shock Load
FITTINGS
Size
No.
Catalog
No.
UPC No.
020418
Tap Size (M)
UNC-2B
Working
Load Limit A Dim. C Dim. D Dim. E Dim. F Dim. G Dim. S Dim. T Dim.
2 7100103 100420 3/8 in 1250 lb 1-5/8 in 1 in 1-17/64 in 3/4 in 9/16 in 15/32 in 5/16 in 2-3/64 in 0.20 lb
3A 7100105 100444 1/2 in 2250 lb 2 in 1-1/4 in 1-1/2 in 1 in 13/16 in 19/32 in 3/8 in 2-15/32 in 0.28 lb
4 7100106 100451 5/8 in 3600 lb 2-1/2 in 1-1/2 in 2-1/32 in 1-3/16 in 1 in 3/4 in 1/2 in 3-9/32 in 0.55 lb
5 7100107 100468 3/4 in 5200 lb 3 in 1-3/4 in 2-7/16 in 1-7/16 in 1-1/4 in 7/8 in 5/8 in 3-15/16 in 1.13 lb
6 7100108 100475 7/8 in 7200 lb 3-1/2 in 2 in 2-9/16 in 1-5/8 in 1-3/8 in 1 in 3/4 in 4-5/16 in 1.53 lb
7 7100109 100482 1 in 10000 lb 4 in 2-1/4 in 3-1/16 in 1-15/16 in 1-5/8 in 1-1/4 in 7/8 in 5-3/16 in 2.75 lb
8 7100111 100505 1-1/4 in 15200 lb 4-1/2 in 2-1/2 in 3-1/2 in 2-1/8 in 1-13/16 in 1-5/16 in 1 in 5-13/16 in 3.80 lb
Weight
Each
104
www.campbellchainandfittings.com