Fee Guidelines for Engineering Services Table Of Contents - APEGBC

Contents
Table of Contents
Foreword
Section A
Section B
Section C
Table 1
Table 2
Table 3
Table 4
Print
Print this Section
Go To...
Articles for Clients
Home ¤
Help ?
Exit ➠
Fee Guidelines for Engineering Services
These methods are explained in detail in Sections B and C of this document
together with recommendations regarding which is most applicable for each
Category of Service outlined in Table 1.
Disbursements, not included in these methods, are additional to them and
are determined as in Subsection A6.
Method 1: Time Basis
Time Basis is recommended when the scope of engineering services is difficult
to determine, cannot be determined, is not well defined, or when the
consultant is not in total control of the required time and disbursements at
any stage of the project (refer to Sections B and C for its calculation).
In addition to the Categories of Service outlined in Table 1, all time expended
on the assignment is billable, including travel, time in the consulting engineer's
office and time on the client's premises or elsewhere. This billable time
also applies to technical and clerical services including, but not limited to,
scheduling, stenographic and clerical staff engaged on correspondence and
documents such as reports and specifications.
➤
Previous Page
Next Page ➤