AEROBRISE LOUVRE SYSTEMS - Hunter Douglas Commercial

AEROBRISE LOUVRE SYSTEMS – TYPICAL CONFIGURATIONS
Mitred Joint
Reveal Plate
SHORT FORM SPECIFICATION
AEROBRISE 70
……….m2 Aluminium Aerobrise 70 Sun Louvre System,
supplied by Hunter Douglas Commercial, is an aluminium
fi xed / adjustable screen, consisting of extruded elliptical
louvres 70mm wide and 15mm deep, fi xed to a
40 x 50mm / 40 x 60mm extruded aluminium frame,
all in selected powder-coat / anodised fi nish, colour
………. Frame size ……….mm width x ……….
mm height. Louvres spaced at ……….mm centres to
achieve a ………. horizontal sun angle. Supply and
install according to the fi xing instructions of Hunter
Douglas Commercial, a division of Hunter Douglas
Limited.
AEROBRISE 150, 200, 300
……….m2 Aluminium Aerobrise 150 / 200 / 300 Sun
Louvre System, supplied by Hunter Douglas Commercial,
is an aluminium fi xed / adjustable system, consisting of
extruded elliptical louvres 150 / 200 / 300mm wide and
© Copyright 2009. Hunter Douglas Limited ABN 98 009 675 709. C7970/02.09
Closed Position Maximum Open Position
Operable Systems
20 / 25 / 40mm deep. The supporting framework shall
be Hunter Douglas Commercial Facade Beams, all in
selected powder-coat / anodised fi nish, colour ……….
1. The louvre blades shall be fi xed at 45o between the
100 x 50mm frame by the use of Hunter Douglas
Commercial reveal plates and fasteners as specifi ed.
OR
2. The louvre blades shall be face fi xed at 45o to the
supporting framework to give a continuous run
of louvre blades by means of the Hunter Douglas
Commercial face fi xing / side fi xing bracket.
OR
3. The louvre blades shall be fi xed at the required
angle ………. to the supporting framework to give
a continuous run of louvre blades by means of the
Hunter Douglas Commercial adjustable mounting
bracket.
OR
45º
45º
Operable End Plate
Standard End Plate
Typical Section of Aerobrise
Louvre Blade
Face Fix Bracket Side Fix Bracket
Fixed Systems
Horizontal Face Fix Bracket
70mm 150mm 200mm 300mm 400mm 450mm 500mm 600mm
Technical data is subject to change without notice. Refer to our Technical and Customer Support Team for further assistance.
4. The louvre blades shall be mounted into the supporting
frame by means of a stainless steel stub axle bolted
through the aluminium end plate and seated into
a nylon bush in the frame. The end plates shall be
connected by means of a linkage bar. The louvres shall
be power operated by means of a linear actuator pivot
mounted on the frame and connected to the linkage
tube.
The support framework shall be constructed from Hunter
Douglas Commercial Box Facade Beams / Heavy Duty
Facade Beams using the Hunter Douglas Commercial
proprietary brackets and plates in accordance with the
manufacturer’s standard details.
Supply and install according to the fi xing instructions of
Hunter Douglas Commercial, a division of Hunter Douglas
Limited.
Hunter Douglas Commercial
Division of Hunter Douglas Limited
338 Victoria Road, Rydalmere, NSW 2116
Phone: 1300 651 968
Email: enquiries@hunterdouglas.com.au
www.hunterdouglascommercial.com.au