emWin - SEGGER Microcontroller

Hardware configuration
This driver accesses the hardware with the indirect interface. The following table lists
the macros which must be defined for hardware access:
Macro Description
LCD_WRITE_A0 Write a byte to LCD controller with A-line low.
LCD_WRITE_A1 Write a byte to LCD controller with A-line high.
LCD_WRITEM_A1 Write multiple bytes to display controller with A-line high.
LCD_READM_A1
Read multiple bytes from display controller with A-line high. Required
only if no display data cache is configured.
If the display size in X is smaller than the number of segment outputs
LCD_FIRSTPIXEL0
of the display controller, this macro can be used for defining the first
visible pixel of the display. It should be used if the first segment lines of
the display controller are not connected to the display.
Additional configuration switches
The following table shows optional configuration switches available for this driver:
LCD_CACHE
Macro Description
When set to 0, no display data cache is used, which slows down the
speed of the driver. Default is 1 (cache activated).
UM03001 User & Reference Guide for emWin V5.18 © 1997 - 2012 SEGGER Microcontroller GmbH & Co. KG
991