PACS MSDS EN

Safety Data Sheet
Acc. to EU Regulations 1907/2006 (REACH), 1272/2008 [CLP] and 2015/830
Product Name : Polyaluminium chloride hydroxide sulfate
Date of issue : 28 July 2015 SDS No : SDS-ACH-01
Revision Date : 04 July 2016 Revision No : 01 Page No : 6 / 12
Substance/mixture related measures to prevent exposure: Administrative and engineering measures
described below should be applied in order to prevent environmental exposures or decrease to a possible
minimum level:
Instruction measures to prevent exposure : Procedures for preventing discharge to environment
control procedures and instructions.
Organizational measures to prevent exposure :
and control equipment in stock.
and spill
Keep sufficient amount of suitable containment material
Technical measures to prevent exposure : It is suggested to have secondary containment solutions in
storage spaces in order to prevent exposure to environment.
9. Physical and chemical properties
9.1 Information on basic physical and chemical properties
a. Appearance : Transparent liquid
b. Odor : Odorless
c. Odor threshold : Not applicable
d. pH : 3.5 – 6.5 (5% solution at 20 o C)
e. Melting point /freezing point : - 12 o C
f. Initial boiling point and boiling range : approx. 105 o C
g. Flash point : Not applicable
h. Evaporation rate : No data
i. Flammability (solid, gas) : Material is not flammable
j. Upper/lower flammability or exposure limits : Not applicable
k. Vapor pressure : No data
l. Vapor density : Not applicable
m. Relative density : 1.05 – 1.35 g/cc at 20 o C
n. Solubility(ies) : Material is a liquid substance. Miscible with water.
o. Partition coefficient : n-octanol/water : Not applicable
p. Auto-ignition temperature : Not applicable
q. Decomposition temperature : No data available
r. Viscosity : 10 – 50 mPa.s (Dynamic , at 20 o C)
s. Explosive properties : Not explosive
t. Oxidizing properties : Not oxidizing
9.2 Other information: PACS contains 5 – 23.5 % Al 2 O 3 .
10. Stability and reactivity
10.1 Reactivity : There are no hazardous reactions under regular storage and uses.
10.2 Chemical stability: Material is stable under normal conditions .
10.3 Possibility of hazardous reactions : There are no hazardous reaction known and no hazardous polymerization.
10.4 Conditions to avoid : Do not store at temperatures higher than 55 o C. It may cause slippery action on the
ground depending on the structure of the ground. Tendency to hydrolyze is low.
10.5 Incompatible materials : Do not store with acids and oxidizing material. Prevent contact with chlorites,
hypochlorites and sulfites. Incompatible with Iron salts and other polyaluminium salts. Necessary precautions
should be taken to prevent mixing PACS with these where those salts used before. PACS should not be stored