PACS MSDS EN

More documents

Recommendations

Info

Safety Data Sheet Acc. to EU Regulations 1907/2006 (REACH), 1272/2008 [CLP] and 2015/830 Product Name : Polyaluminium chloride hydroxide sulfate Date of issue : 28 July 2015 SDS No : SDS-ACH-01 Revision Date : 04 July 2016 Revision No : 01 Page No : 6 / 12 Substance/mixture related measures to prevent exposure: Administrative and engineering measures described below should be applied in order to prevent environmental exposures or decrease to a possible minimum level: Instruction measures to prevent exposure : Procedures for preventing discharge to environment control procedures and instructions. Organizational measures to prevent exposure : and control equipment in stock. and spill Keep sufficient amount of suitable containment material Technical measures to prevent exposure : It is suggested to have secondary containment solutions in storage spaces in order to prevent exposure to environment. 9. Physical and chemical properties 9.1 Information on basic physical and chemical properties a. Appearance : Transparent liquid b. Odor : Odorless c. Odor threshold : Not applicable d. pH : 3.5 – 6.5 (5% solution at 20 o C) e. Melting point /freezing point : - 12 o C f. Initial boiling point and boiling range : approx. 105 o C g. Flash point : Not applicable h. Evaporation rate : No data i. Flammability (solid, gas) : Material is not flammable j. Upper/lower flammability or exposure limits : Not applicable k. Vapor pressure : No data l. Vapor density : Not applicable m. Relative density : 1.05 – 1.35 g/cc at 20 o C n. Solubility(ies) : Material is a liquid substance. Miscible with water. o. Partition coefficient : n-octanol/water : Not applicable p. Auto-ignition temperature : Not applicable q. Decomposition temperature : No data available r. Viscosity : 10 – 50 mPa.s (Dynamic , at 20 o C) s. Explosive properties : Not explosive t. Oxidizing properties : Not oxidizing 9.2 Other information: PACS contains 5 – 23.5 % Al 2 O 3 . 10. Stability and reactivity 10.1 Reactivity : There are no hazardous reactions under regular storage and uses. 10.2 Chemical stability: Material is stable under normal conditions . 10.3 Possibility of hazardous reactions : There are no hazardous reaction known and no hazardous polymerization. 10.4 Conditions to avoid : Do not store at temperatures higher than 55 o C. It may cause slippery action on the ground depending on the structure of the ground. Tendency to hydrolyze is low. 10.5 Incompatible materials : Do not store with acids and oxidizing material. Prevent contact with chlorites, hypochlorites and sulfites. Incompatible with Iron salts and other polyaluminium salts. Necessary precautions should be taken to prevent mixing PACS with these where those salts used before. PACS should not be stored
Safety Data Sheet Acc. to EU Regulations 1907/2006 (REACH), 1272/2008 [CLP] and 2015/830 Product Name : Polyaluminium chloride hydroxide sulfate Date of issue : 28 July 2015 SDS No : SDS-ACH-01 Revision Date : 04 July 2016 Revision No : 01 Page No : 7 / 12 together with the incompatible material listed above. PACS may cause corrosion on the surface of some metals like aluminum, copper, zinc, galvanized metals and alloys of those metals. 10.6 Hazardous decomposition products : If PACS is heated up to dryness at temperatures above 200 o C, emits hydrogen chloride (HCl) and sulfur oxide (SO x ) gases. 11. Toxicological information 11.1 Information on toxicological information : No toxicity test for PACS has been performed. pH and acid/alkaline reserve tests performed. Test result: Not corrosive and not irritant for eye and/or skin. Acute toxicity: There are no acute toxicity data available. Skin corrosion / irritation: Test result: not corrosive, not irritant (pH and acid/alkaline reserve test) Serious eye damage/irritation: Testresult: not corrosive, not irritant (pH and acid/alkaline reserve test) Respiratory or skin sensitization : No sensitizing effect known Germ cell mutagenity: No effects known Carcinogenity: This product is not considered to be a carcinogen by IARC, ACGIH. Reproductive toxicity : No data available Summary of evaluation of the CMR properties : STOT- single exposure : No data available STOT – repeated exposure: Aspiration hazard : No data available No data available. No data available Other info: RTECS : no data available. There are no sufficient study and data on the toxicology of this substance (TOXNET). 12. Ecological information 12.1 Toxicity Ecotoxicity of PACS is not determined. 12.2 Persistence and degradability : No data available Abiotic degradation : No data available Physical- and photo-chemical elimination : No data available Biodegradation : No data available 12.3 Bioaccumulative potential : No data available Partition coefficient : n-octanol/water (log Kow) : No data available Bioconcentration factor (BCF) : No data available 12.4 Mobility in soil No data available Known or predicted distribution to environmental compartments: No data available Surface tension: Not applicable Adsorption/Desorption : No data available 12.5 Results of PBT and vPvB assessment : PACS does not meet the criteria for classification as PBT or vPvB. Chemical safety assessment for PACS has not been performed. 12.6 Other adverse effects: No further information available. 12.7 Additional information: No further information available.
Page 1 and 2: Safety Data Sheet Acc. to EU Regula
Page 5: Safety Data Sheet Acc. to EU Regula

PACS MSDS EN

Create successful ePaper yourself

Delete template?

Save as template?