Water cooling tower GRP cooling tower ctp engineer

REASONS FOR THE DROP İN COOLİNG TOWER OPERATİNG PERFORMANCE?
PARADISE IN THE TOWER OR LIME, LIQUIDS MAY BE NON-CLASSIFIED (IT IS PHYSICALLY CONTROLLED
WITH THE TOWER AND THE INTERNAL EYE?)
If the feeding water is not lime-free with the softener, the lime formation usually grows as the soil
gradually grows. Small limescale particles are first accelerated to a thin film layer before each point
on the surface, forming a surface that can be easily seen on the surface in the form of sediment and
calcification. It is possible to form bacteria even at the level where the temperature, fresh air, dark or
light areas are considerably large, and in the cooling towers which do not have the proper
conditioning, clog up the fillings.
PARADE CREATIONS IN THE TOWER FAN WINGS MAY BE BALANCED. (Is the parasitic formation
obsolete in the fan wings?)
Particularly, the parasites that grow very rapidly with the load humidity in the region where the fan is
located, seen in the intermittently stopped podiums, cause the fan balance in negative direction
when they form colony on the fan wings and reach effective weight.
THE FAN MOTOR IS LIQUIDATED OR THE FAILURE OF THE FAN MOTOR CONNECTIONS. (MOTOR AND
ENGINE CONNECTIONS HAVE CONTROLLED?)
The fan motor connections must be visually checked, the tower must be at a standstill during this
check, and these checks should not be carried out while running. If the motordan is coming from a
burning resin odor or scintillating smell, this means that there is a burning in the windings of the
motor, a burn in the pole heads or a deterioration in the bearings. In systems where the fan is
directly connected to the motor, the motor fan connection must be connected as tightly as possible,
so that it will not loosen.
YOU MAY CHANGE BUSINESS CONDITIONS. (WAS THERE A CHANGE IN OPERATIONAL CONDITIONS
WHICH HAD BEEN DURING YOUR INSTALLATION?)
The towers will not be able to respond to clogs at full capacity selected towers, to off-line falls,
seasonal capacity shortfalls outside the water distribution system and fountains, fan and engine
failures, and increased capacities due to changes and failures in existing operating conditions.
WATER TEMPERATURE MAY BE INCREASED. (INSTALLED, INCREASING, INCREASING, INCREASING IN
WATER TEMPERATURE?)
Capacity changes in cycle pumps in water cooling towers directly affect tower performance. The
tower capacity, which is directly related to the warmth of the incoming waters and to the waters, will
be markedly ineffective by one or more of these factors changing.
MAY BE CHANGED IN THE TOWER POSITION. (WAS THERE A CHANGE IN THE TOWER LOCATION?)