Water cooling tower GRP cooling tower ctp engineer

Motor power
Chimney diameter
Number of fan blades
Depending on the amount of fluid flow
Pipe diameters (pressure dependent on diameter)
Number and type of nozzles to be used
Filler air velocity
Filler unit water load
are reached.
There are many issues to be considered in design.
For example: water distribution system should be selected correctly according to tower inlet and
outlet temperatures.
If the Pvc-u or PPrc (copolymer-added PP) materials are not selected at the correct temperature,
breaks will occur due to softening the pipe or too much hardness.
Another issue in water distribution systems is the choice of pipe with appropriate pressure durability.
GRP (glass fiber reinforced polyester) stands out in the selection of polyester which is the building
stone of the material. The use of orthophthalic polyester is more important in the selection of
isophthalic polyester at higher temperatures.
If there is acidic basic density in the system, vinil polyester should be preferred.
The choices made by considering the design values are as important as the least complex design
calculations.
If, for example, the "fill air speed" is too high, unnecessary water exits will be observed in the form of
rain from the end of the water transport. This is definitely an unwanted condition and will cause
leakage by increasing water consumption.
Or, if it is below normal, insufficient heat transfer will not be used in efficiency where the resulting
tower can be used.
Another example can be given for the "rain water density" (rain density). Sometimes the tower flow
is quite high and the design of the tower is very small when the temperature difference (delta t) is
low.
In the case of overheating, the heat transfer between air and water is not efficient. In theory, it can
not be realized due to the fact that the heat transfer unit which is envisaged to be easily made has a