H100_User Manual_Standard_V2.8_191030_EN

Table of Contents
4.2.1 Keypad as the Source (KeyPad-1 setting) ................................ 87
4.2.2 Keypad as the Source (KeyPad-2 setting) ................................ 87
4.2.3 V1 Terminal as the Source ......................................................... 88
4.2.4 Setting a Frequency Reference with Input Voltage (Terminal I2)
.................................................................................................... 96
4.2.5 Setting a Frequency with TI Pulse Input ................................... 97
4.2.6 Setting a Frequency Reference via RS-485 Communication .. 99
4.3 Frequency Hold by Analog Input .......................................................... 100
4.4 Changing the Displayed Units (Hz↔Rpm) .......................................... 101
4.5 Setting Multi-step Frequency ................................................................ 101
4.6 Command Source Configuration.......................................................... 103
4.6.1 The Keypad as a Command Input Device .............................. 103
4.6.2 Terminal Block as a Command Input Device (Fwd/Rev run
commands) .............................................................................. 104
4.6.3 Terminal Block as a Command Input Device (Run and Rotation
Direction Commands) ............................................................. 105
4.6.4 RS-485 Communication as a Command Input Device .......... 106
4.7 Forward or Reverse Run Prevention ................................................... 107
4.8 Power-on Run ....................................................................................... 108
4.9 Reset and Restart ................................................................................. 110
4.10 Setting Acceleration and Deceleration Times ...................................... 111
4.10.1 Acc/Dec Time Based on Maximum Frequency ...................... 111
4.10.2 Acc/Dec Time Based on Operation Frequency ...................... 113
4.10.3 Multi-step Acc/Dec Time Configuration ................................... 113
4.10.4 Configuring Acc/Dec Time Switch Frequency......................... 116
4.11 Acc/Dec Pattern Configuration ............................................................. 117
4.12 Stopping the Acc/Dec Operation .......................................................... 120
4.13 V/F (Voltage/Frequency) Control .......................................................... 121
4.13.1 Linear V/F Pattern Operation ................................................... 121
4.13.2 Square Reduction V/FPattern Operation ................................ 122
4.13.3 User V/F Pattern Operation ..................................................... 123
4.14 Torque Boost ......................................................................................... 125
4.14.1 Manual Torque Boost................................................................ 125
4.14.2 Auto Torque Boost .................................................................... 126
4.14.3 Auto Torque Boost 2 (No Motor Parameter Tuning Required)
.................................................................................................. 126
4.15 Output Voltage Setting .......................................................................... 127
4.16 Start Mode Setting................................................................................. 128
vi