Millboard 120WT MSDS - Unifrax

More documents

Recommendations

Info

2. COMPOSITION / INFORMATION OF INGREDIENTS COMPONENT CAS NUMBER SYMBOL R PHRASES Aluminium silicate 1318-74-7 None None Calcium silicate 13983-17-0 None None COMPOSITION Cellulose 9004-34-6 None None Millboards 120WT: 43-46% Calcium silicate, 40-45% Aluminium silicate,
METHODS FOR CLEANING UP Pick up large pieces and use a vacuum cleaner fitted with high efficiency filter (HEPA) If brushing is used, ensure that the area is wetted down first. Do not use compressed air for clean-up. Do not allow to be wind blown. Do not flush spillage to drain and prevent from entering natural watercourses. Check for local regulations, which may apply. For wastes disposal refer to section 13 7. HANDLING AND STORAGE HANDLING / TECHNIQUES TO REDUCE DUST EMISSIONS DURING HANDLING HANDLING Handling can be a source of dust emission. The Process or processes should be designed to limit the amount of handling. Whenever possible, handling should be carried out under controlled conditions (i.e., use dust exhaust system). Regular good housekeeping will minimise secondary dust dispersal. STORAGE Store in original packaging in dry area whilst awaiting use Always use sealed and visibly labelled containers. Avoid damaging containers. Reduce dust emission during unpacking. Emptied containers, which may contain debris, should be cleaned before disposal or recycling. HYGIENE STANDARDS AND CONTROL MEASURES 8. EXPOSURE CONTROL / PERSONAL PROTECTION Hygiene standards and occupational exposure limits may vary between countries and local jurisdictions. Check which exposures apply to your facility. If no regulatory dust or other standards apply, a qualified industrial hygienist can assist with a specific workplace evaluation including recommendations for respiratory protection. Examples of exposure limits are given below: Exposure limit in January 2008 as given below: United Kingdom – Workplace Exposure Limits – HSE EH 40 Total inhalable dust mg/m 3 Respirable dust mg/m 3 Calcium Silicate 10 4 Aluminium Silicate 10 4 ENGINEERING CONTROLS Review your application(s) in order to identify potential sources of dust exposure. MSDS 3050E Rev 1 Page 3 of 7 Last Rev 20 Sept 2008
Page 1: MATERIAL SAFETY DATA SHEET (EUROPEA
Page 5 and 6: RESPIRATORY EFFECTS None expected i
Page 7: to practice any patented invention

Millboard 120WT MSDS - Unifrax

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?