ThorPlas Engineering Manual - Thordon Bearings

APPLICATION DESIGN
g) Machining Tolerances
14
Figure 12: ThorPlas Machining Tolerances
A- Bearing OD Machining Tolerances
METRIC: Tolerance
Bearing OD Bearing Length on OD(mm)
Up to 150mm
150 to 250mm
up to 100mm +/-0.03
above 100mm +/-0.05
up to 150mm +/-0.05
150 to 250mm +/-0.07
250mm and up maximum L/D of 1:1 +/-0.07
IMPERIAL:
Tolerance
Bearing OD Bearing Length on OD(in.)
Up to 6.00”
6.00” to 10.00”
up to 4.00” +/-0.001
above 4.00” +/-0.002
up to 6.00” +/-0.002
6.00” to 10.00” +/-0.003
10.00” and up maximum L/D of 1:1 +/-0.003
B- Bearing WALL THICKNESS Machining Tolerances
METRIC: Tolerance
Bearing OD Bearing Length on Wall(mm)
Up to 150mm
up to 100mm
+0.00
-0.03
above 100mm
+0.00
-0.05
150 to 250mm
up to 150mm
+0.00
-0.05
150 to 250mm
+0.00
-0.07
250mm and up
maximum L/D +0.00
of 1:1 -0.07
IMPERIAL: Tolerance
Bearing OD Bearing Length on Wall(in.)
Up to 6.00”
up to 4.00”
+0.000
-0.001
above 4.00”
+0.000
-0.002
6.00” to 10.00”
up to 6.00”
+0.000
-0.002
6.00” to 10.00”
+0.000
-0.003
10.00” and up
maximum L/D +0.000
of 1:1 -0.003
C- Bearing LENGTH Machining Tolerances
METRIC:
Bearing Length Tolerance on LENGTH(mm)
Up to 150mm
150 to 250mm
250mm and up
+0.00
-0.25
+0.00
-0.50
+0.00
-1.00
IMPERIAL:
Bearing Length Tolerance on LENGTH(in.)
Up to 6.00”
6.00” to 10.00”
10.00” and up
+0.000
-0.010
+0.000
-0.020
+0.000
-0.040
D- ThorPlas Washer Tolerances
METRIC:
Bearing Dimension Tolerance(mm)
OD
ID
+0.00
-1.00
+1.00
-0.00
Thickness +/-0.50
IMPERIAL:
Bearing Dimension Tolerance(in.)
OD
+0.000
-0.040
ID
+0.040
-0.000
Thickness +/-0.020