Routing Protocols Configuration Guide for the SmartEdge OS ...

• IP Services and Security Operations Guide for the SmartEdge OS
Intended Audience
Describes the tasks and commands used to monitor, administer, and troubleshoot the SmartEdge OS
features described in the IP Services and Security Configuration Guide; commands include all clear,
debug, and show commands, along with other operations-based commands.
• SmartEdge 800 Router Hardware Guide
Describes the SmartEdge 800 hardware and provides site preparation information and installation,
monitoring, and maintenance procedures for the chassis and cards.
• SmartEdge 400 Router Hardware Guide
Intended Audience
Organization
Describes the SmartEdge 400 hardware and provides site preparation information and installation,
monitoring, and maintenance procedures for the chassis and cards.
This guide is intended for system and network administrators experienced in access and internetwork
administration.
This guide is organized as follows:
• Part 1, “Introduction”
Describes network routing with the SmartEdge OS, supported routing protocols and routing
related-features, the routing-related command hierarchy, and the routing-related access command
modes and system prompts.
• Part 2, “IP Routing”
Describes the SmartEdge OS tasks and commands used to configure basic IP routing, including static
IP routing; DVSR; VRRP; RIP and RIPng; OSPF and OSPFv3; BFD; BGP; BGP/MPLS VPNs; IS-IS;
IP multicast routing, including IGMP, MSDP, and PIM; and routing policies.
• Part 3, “MPLS Routing”
Describes the SmartEdge OS tasks and commands used to configure MPLS, L2VPNs, LDP, and VPLS.
Note There are three indexes in this guide: an index of tasks and features, an index of commands, and an
index of CLI modes with the commands found within each mode.
About This Guide xxiii