BSS500 instructions
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
MODEL : <strong>BSS500</strong><br />
BLIND SPOT<br />
DETECTION SYSTEM<br />
QUALITY PRODUCTS FOR THE PROFESSIONAL INSTALLER
MODEL : <strong>BSS500</strong><br />
TABLE OF CONTENTS<br />
INTRODUCTION 3<br />
Contents<br />
INSTALLATION/MOUNTING 4 - 11<br />
TROUBLESHOOTING 12<br />
QUICK START 13 - 16
MODEL : <strong>BSS500</strong><br />
INTRODUCTION<br />
Congratulations on your purchase of the Optix “Blind Spot Detection System”. With “<strong>BSS500</strong>” installed, you are able<br />
to receive a visual and audible indication that a vehicle is approaching the blind spot area from behind. This is an OEM<br />
like system and drilling is required on the bumper.<br />
Contents<br />
1- <strong>BSS500</strong> module<br />
2- Sensor<br />
1- Main Harness x 1<br />
1- Display Cable<br />
2- Alcohol pad<br />
2- Magnets
MODEL : <strong>BSS500</strong>
MODEL : <strong>BSS500</strong>
Bi- Bi- Bi-<br />
MODEL : <strong>BSS500</strong>
Parking light<br />
MODEL : <strong>BSS500</strong>
MODEL : <strong>BSS500</strong>
MODEL : <strong>BSS500</strong><br />
3<br />
Find out the sensor installation<br />
Make sure the sensor location calibration tool<br />
parallel to car body, then the hypotenuse of<br />
right angled triangle and rear bumper will<br />
overlap. The overlap point is the sensor<br />
installation angle.<br />
Using a mark pen to make marks on bumper.<br />
Overlap point<br />
Mark down
MODEL : <strong>BSS500</strong><br />
4<br />
45cm
*<br />
**<br />
MODEL : <strong>BSS500</strong><br />
**<br />
***
MODEL : <strong>BSS500</strong>
MODEL : <strong>BSS500</strong><br />
BLIND SPOT<br />
DETECTION SYSTEM<br />
QUICK START<br />
QUALITY PRODUCTS FOR THE PROFESSIONAL INSTALLER
MODEL : <strong>BSS500</strong><br />
Bi- Bi- Bi-
MODEL : <strong>BSS500</strong><br />
3<br />
3<br />
Find out Find the sensor out the installation sensor installation<br />
Make sure Make the sensor sure the location sensor calibration location calibration tool tool<br />
parallel to parallel car body, to then car body, the hypotenuse then the hypotenuse of of<br />
right angled right triangle angled and triangle rear bumper and rear will bumper will<br />
overlap. The overlap. overlap The point overlap is the point sensor is the sensor<br />
Overlap point Overlap point<br />
installation installation angle. angle.<br />
Using a mark Using pen a to mark make pen marks to make on bumper. marks on bumper.<br />
Mark downMark down
*<br />
**<br />
MODEL : <strong>BSS500</strong><br />
4<br />
4<br />
45cm