Инструкция к автомобильному усилителю Audison ... - Car Media

Fans group insertion inside Terminals and Raccords
INSTRUCTIONS
Put the Terminal or the Raccord onto a flat surface. (As far as Terminals are concerned, the side with grilles must
be facing upwards). Remove the front plate fixed through four screws by using multispanner supplied with the
devices (pict. 1 and 2). Place the fans groups onto the flat surface and push them in order to insert them inside the
extension body you are using, so that the fans group support guides snap into the slots (pict. 3).
Warning!: Do not push hard onto the fans wheel while mounting the fans group.
General procedure for insertion inside Terminals
1 2
TRM4 and TRM6 TRM4 and TRM6
TRM4 and TRM6
TRM6
3
TRM4 and TRM6
General procedure for insertion inside Raccords
4
Remark for TRM6:
Insert the special spacers inside TRM6 in
order to avoid air flux dispersion by making
them slide onto the terminal proper slots
until they touch the fans.
After inserting the fans, mount
Terminals front plate back again
(pict. 4). If parts were assembled in
the right way, the fans wheels will
be in the same side as the grilles of
the plate itself.
car-media.com.ua
Remark for TRM4:
Do not turn the Terminal body while
mounting it. Its correct direction is
when the screw in the wooden strip
is closer to the flat surface the
terminal lies onto (pict. 2).
Remark for Raccords:
Inputs and outputs:
bridge connection
VR
Power supply, remote and acce
Please
Feature
fuse siz
order to
proper