01.01.2013 Views

Инструкция к автомобильному усилителю Audison ... - Car Media

Инструкция к автомобильному усилителю Audison ... - Car Media

Инструкция к автомобильному усилителю Audison ... - Car Media

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

Note:<br />

Note:<br />

VRx6.420<br />

Front/Rear configurations<br />

Channels are driven by PC36 (PC36 always takes signal from IN1)<br />

Sub is driven by IN1 + IN2 NO FADING SUB (with active Constant Bass)<br />

Multichannel Configurations<br />

Channels are driven by PC36 (PC36 always takes signal from IN1).<br />

Sub is driven by IN1 + IN2.<br />

IN2 = Sub level: Sub is driven by IN1 + IN2. Fader is used to adjust sub level.<br />

IN2 = Not used: Sub and Front driven by IN1.<br />

A, B and C bridged amplifiers configurations<br />

MA, MB and MC on position 2 (mono)<br />

car-media.com.ua<br />

GENERAL FEATURES<br />

Conformity with “E” norms<br />

VRx models have a RF filter which makes<br />

emission inside cars before any others. A<br />

next to power supply input in order to pr<br />

typologies.<br />

Thermal limiter onto transformers<br />

A very effective protection circuit was pu<br />

which might be dangerous for the amplif<br />

will start to function again only after the n<br />

be carried out.<br />

LNS (Line Noise Suppressor) circuit<br />

LNS circuit allows the system low freque<br />

electrical parts (alternator, electronic injec<br />

special switch which is onto all models ex<br />

permits to check if its intervention is nece<br />

TPC.2 (Twin Power Controller) power s<br />

TPC.2 allows to increase power supply sta<br />

impulsive power and lower stress of filter<br />

OCN (Off Current Null) and DVP (Dam<br />

Thanks to OCN circuit, VRx models are th<br />

when amplifier is off. Their value (0.00005<br />

circuit protects VRx amplifiers from voltag<br />

Synchro-PWM power supply<br />

Power supply stage consists of two totall<br />

negative voltages. It is therefore possi<br />

guaranteeing higher energy and speed w<br />

Final stage driver modules: LD1.2 and<br />

Final stage driver modules (LD1.2 for VRx2<br />

sound characterisation. Subjected to conti<br />

acoustic impact with low frequencies in th<br />

DFL (Distortion Frequency Limiter) circ<br />

DFL circuit is a real electronic protection fo<br />

and to 2% onto high ones. This implies co<br />

margin for all speakers in the system.<br />

Sub input (VRx6.420)<br />

VRx6.420 PRE OUT output can be used a<br />

have a third preamplified output for the s<br />

RGP input stages protection (Resettab<br />

RGP is an electronic protection able to de<br />

the device in “stand by” condition (safety)<br />

the amplifier is off, allowing the interrupt

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!