Refrigeration . Air conditioning . Heating - Dehon

Oil Analysis
Ref. Products Comments
789 Viscosity at 40°C Measures kinematic viscosity.
785 Acidity rate Measures the acidity of the lubricant.
787 Element contents Identifies and quantifies the following elements : B-P-Zn-Fe-Cr-Si-Ba-
Mg-Cu-Mo-Sn-Pb-Cd-Al-Ni-Ca-Sb-Ag-Na.
786 Water content Measures the water content of the lubricant.
788 Dielectric rigidity Measures the electrical isolation qualities of the lubricant.
4962 Ferrography oil Identifies and quantifies the particles present in the lubricant.
6083 Particle counting Determines the number of particles by size. Allows the correct size
filter to be selected.
6084 Infrared spectrum Identifies the nature of an unmixed lubricant.
6548 Kit gravimetric pollution Measures the particle mass of the lubricant.
880 Acitest Box of 6. Acidity test for all types of oils that do not contain additives
(mineral, alkylbenzene, ester…).
6096 Universal acitest Box of 6. Acidity test for all types of oils, whether or not they contain
additives (mineral, alkylbenzene, ester…).
• DPH : Periodic diagnostic test on the refrigerant oil in a circuit
Periodic diagnostic test on the refrigerant oil in a circuit. The values obtained are compared with both standard
values and Climalife recommendations.
875 DPH A Appearance + viscosity + acid index + water content + elements
indicating wear + additives + contaminants. 1 x 60 ml bottle.
876 DPH B Idem DPH A + dielectric rigidity. 1 x 500 ml bottle.
877 DPH E Used to determine the percentage of oil remaining after a retrofit.
Physico-chemical state is compared with a control sample. 3 x 60 ml
bottles.
3978 DPH R After a DPH E, determines the percentage of the original oil remaining
after the subsequent operations to change the oil. 1 x 60 ml bottle.
6035 Kit for specific analysis 4 tests to analyse viscosity, water content, acidity and the presence
of the 5 elements which indicate wear (Fe, Zn, Cu, Al, Si).
6035
875
6096
66
ANALYSiS