SWING SHOWER DOOR Models Nos. - Sterling

More documents

Recommendations

Info

2 part names for installation Anchor No. 8-32 Nut No. 8 Cup Washer Plug Bracket No. 8-32 x 5⁄16" Undercut Head Screw Pin " L" Jamb No. 8-18 x 1⁄2" Panhead Screw Bracket No. 8-18 x 2" Panhead Screw No. 8-32 x 3⁄4" Panhead Screw Pin Washer Door Panel Flat Seal No. 8-18 x 1⁄2" Panhead Screw Bottom Track Seal Strike Jamb Bottom Track Wall Jamb Anchor No. 8-18 x 2" Panhead Screw
1MEASURING AND CUTTING BOTTOM TRACK A. B. 2 A. B. DETERMINING DIRECTION OF <strong>SWING</strong> Determine whether the door will swing toward the right or left. Check that there are no obstacles in the door path as it swings open. It is recommended that the swing side of the door be installed on the opposite side from the showerhead. Be sure there are no obstructions. All of the following illustrations are for door that swings open toward the left. Door that swings open toward right would be opposite. 3PLACING BOTTOM TRACK ON <strong>SHOWER</strong> LEDGE A. B. NOTE: WEAR SAFETY GLASSES. Note: If your stall has a curve in the corners at the side walls, be sure to measure distance D above the curves and cut bottom track 1 1 ⁄8" shorter than distance D. Measure distance D from wall to wall as shown and cut the bottom track 1 1 ⁄8" shorter than distance D. For best results use a 32-tooth per inch hacksaw blade and miter box. File rough edges. CAUTION: If a steel tape is used, be sure to add the width of the case to the measurement. NOTE: Locate bottom track on flattest part of ledge. Place the bottom track on the ledge as shown. Make sure the space between the wall and bottom track is the same on both ends and the distance from the outer edge of the shower ledge to front edge of the bottom track is the same measurement on both ends. Temporarily secure the bottom track with masking tape and mark the shower ledge with a soft pencil along the front edge of the bottom track. Bottom Track D TOP VIEW Swings open toward left TOP VIEW Swings open toward right Inside of Shower 3
Page 1: INSTALLATION INSTRUCTIONS Please re
Page 5 and 6: 5 A. LOCATING "L" JAMB AGAINST WALL
Page 7 and 8: 8 A. B. C. D. E. INSTALLING "L" JAM
Page 9 and 10: 10 A. B. INSTALLING STRIKE EXPANDER
Page 11 and 12: 12 A. B. LOCATING BLOCKS Measure di
Page 13 and 14: 14 A. B. C. 15 A. B. C. INSTALLING
Page 15: Key No. 1 2 3 4 5 6 7 8 9 10 11 12

SWING SHOWER DOOR Models Nos. - Sterling

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?