NM Single Six - Frankonia
NM Single Six - Frankonia
NM Single Six - Frankonia
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
CAUTION: The hammer must be carefully eased fully forward before<br />
the hammer is drawn back to the full-cock position for the first shot.<br />
The hammer should be drawn with a firm positive motion to the fullcock<br />
position for each shot, thus actuating the working parts for<br />
complete indexing. Unless this procedure is followed in any single-action<br />
revolver, the cylinder is apt to be out of index when fired.<br />
TO UNLOAD OR EJECT CARTRIDGE CASES<br />
Keep revolver pointed in a safe direction!<br />
Do not attempt to unload when the hammer is cocked.<br />
If the hammer is cocked, it must first be decocked. (See “To Uncock The<br />
Revolver,” p. 19.)<br />
Then:<br />
1. Open the gate. This permits the cylinder to rotate.<br />
2. Turn cylinder clockwise, by hand, to align a chamber with the ejector rod.<br />
3. Push the ejector rod rearward, by means of the thumb-piece on its forward<br />
end, so that it slides through the chamber to push out the cartridge or fired<br />
case. Release spring-loaded ejector rod. Repeat until all chambers are empty.<br />
4. Check to be certain that all cartridges have been removed, then close the gate.<br />
CORRECT UNLOADING SEQUENCE<br />
Do not eject unfired cartridges onto any surface where the cartridge rim might<br />
strike a solid object and discharge the cartridge.<br />
21<br />
REPEAT<br />
FOR ALL<br />
CHAMBERS