Fiber Optic Passive Components - PENGG KABEL GmbH

Fiber Optic Enclosures
Protective Sleeve SM/2F..+2B
• The protective sleeve is an additional enclosure used for accommodating and protecting cable
reserves and sleeves
• Especially designed for underground laying
• The split design makes it suitable for uncut cables
• Can also be used for the storage of reserve lengths
• 4 Entries for the installation of UF1 universal end fitting (cable entry) or double strain relief cone
(blind plugs for spare entries)
• Integrated support frame for the installation of OM1, OM1/1, OM1/2 and KM3 sleeves
• Integrated support frame for the storage of 2 x 20m cable reserves
• Installation point for an Electronic Marker System (EMS)
• Entries 4x Universal end fitting LWL-UF1/R./KU/00
Tube ø 40 or 50 mm
Cable ø 10-20 mm
• Tests
Mechanical strength
Load (5 min.) 18 kN, contact surface over the entire sleeve
Impact (10 times) 6 kg guillotine, 90 cm fall, at the centre of the sleeve
Impact (once) 7 kg sharp impact device, 80 cm fall, penetration depth < 20 mm at the centre
of the sleeve
Tightness with UF1 universal end fitting: mud-tight
• Material
Top and bottom: Glass-fibre reinforced polyester - yellow (similar to RAL 1018)
Universal end fitting: POM
Support frame: Powder-coated sheet steel, RAL 7035
Screws and washers: Stainless steel
• Weight: Approx. 27 kg
• Scope of delivery: 1 Basic enclosure, 1 support frame, 1 copy of Instructions for Installation, 2
universal end fittings, 2 double strain relief cones, fixing material
86 Fiber Optic Passive Components • 10/2012 • © by Pengg Kabel GmbH • Subject to technical alterations