OM, 2348 LS, (CA), 96043004900, 2008-03, Ride Mower - Husqvarna
OM, 2348 LS, (CA), 96043004900, 2008-03, Ride Mower - Husqvarna
OM, 2348 LS, (CA), 96043004900, 2008-03, Ride Mower - Husqvarna
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
SERVICE AND ADJUSTMENTS<br />
REPLACING BATTERY (See Fig 32)<br />
WARNING: Do not short battery ter mi nals by allowing<br />
a wrench or any other object to contact both terminals at<br />
the same time. Before connecting battery, remove metal<br />
bracelets, wristwatch bands, rings, etc.<br />
Positive terminal must be connected first to prevent sparking<br />
from ac ci den tal grounding.<br />
1. Lift hood to raised position.<br />
2. Disconnect BLACK battery cable (A) then RED battery<br />
cable and carefully remove battery from tractor.<br />
3. Install new battery with terminals in same position as<br />
old battery.<br />
4. First connect RED battery cable (B) to positive (+) battery<br />
terminal with hex bolt and keps nut as shown. Tighten<br />
securely. Slide terminal cover (C) over terminal.<br />
5. Connect BLACK grounding cable to negative (-) bat tery<br />
terminal with re main ing hex bolt and keps nut. Tight en<br />
securely<br />
6. Close hood.<br />
C<br />
POSITIVE<br />
(RED)<br />
<strong>CA</strong>BLE<br />
B<br />
02954<br />
FIG. 32<br />
TO REPLACE HEADLIGHT BULB<br />
• Raise hood.<br />
• Pull bulb holder out of the hole in the backside of the<br />
grill.<br />
• Replace bulb in holder and push bulb holder securely<br />
back into the hole in the backside of the grill.<br />
• Close hood.<br />
A<br />
NEGATIVE<br />
(BLACK)<br />
<strong>CA</strong>BLE<br />
25<br />
INTERLOCKS AND RELAYS<br />
Loose or damaged wiring may cause your tractor to run<br />
poorly, stop running, or prevent it from starting.<br />
• Check wiring. See electrical wiring diagram in the<br />
Repair Parts section.<br />
TO REPLACE FUSE<br />
Replace with 20 amp automotive-type plug-in fuse. The<br />
fuse holder is located behind the dash.<br />
TO REMOVE HOOD AND GRILL ASSEMBLY<br />
(See Fig. 33)<br />
• Raise hood.<br />
• Unsnap headlight wire connector.<br />
• Stand in front of tractor. Grasp hood at sides, tilt toward<br />
engine and lift off of tractor.<br />
• To replace, reverse above procedure.<br />
02778<br />
ENGINE<br />
HOOD<br />
FIG. 33<br />
HEADLIGHT<br />
WIRE<br />
CONNECTOR<br />
TO AD JUST THROTTLE CON TROL <strong>CA</strong>BLE<br />
The throttle control has been preset at the factory and<br />
ad just ment should not be necessary. If adjustment is neces<br />
sary, see engine manual.<br />
TO AD JUST CHOKE CON TROL<br />
The choke control has been preset at the factory and adjust<br />
ment should not be necessary. If adjustment is necessary,<br />
see engne manual.<br />
TO ADJUST <strong>CA</strong>RBURETOR<br />
Your carburetor is not adjustable. If your engine does not<br />
operate properly due to suspected carburetor problems,<br />
take your tractor to an authorized service center for repair<br />
and/or adjustment.