SERVICE MANUAL AIR PURIFIER KC-C100E-W ... - Y. Servis Girişi
SERVICE MANUAL AIR PURIFIER KC-C100E-W ... - Y. Servis Girişi
SERVICE MANUAL AIR PURIFIER KC-C100E-W ... - Y. Servis Girişi
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>KC</strong><strong>C100E</strong>W<br />
�SOLDERING WORK<br />
The melting point of lead-free solder (Sn-Ag-Cu) is approximately<br />
220°C, 40°C higher than conventional solder, and wettability is not as<br />
good. For this reason there is a tendency to keep the soldering iron in<br />
contact with the board for a long time. However, this may cause lifted<br />
lands and heating in excess of the heat tolerance of components, and<br />
thus the soldering iron should be removed from the board as soon as<br />
you have verified that a bond has formed.<br />
Lead-free solder has a higher proportion of tin, which causes<br />
increased corrosion of the tip of the soldering iron, and thus care<br />
should be taken to turn off the soldering iron whenever it is not in use.<br />
Any different type of solder remaining on the tip of the soldering iron<br />
will form an alloy with lead-free solder, thus the tip should be cleaned<br />
after you have finished soldering.<br />
If the tip of the soldering iron turns a dark color while you are soldering,<br />
clean the tip with steel wool or fine-grained sandpaper.<br />
APPLICABLE CIRCUIT BOARDS<br />
PART CODE PART NAME<br />
CPWB-A175KKKZ <strong>C100E</strong> PWB UNIT<br />
iii