SERVICE MANUAL AIR PURIFIER KC-C100E-W ... - Y. Servis Girişi
SERVICE MANUAL AIR PURIFIER KC-C100E-W ... - Y. Servis Girişi
SERVICE MANUAL AIR PURIFIER KC-C100E-W ... - Y. Servis Girişi
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>KC</strong><strong>C100E</strong>W<br />
[2] PROCEDURES FOR RUNNING WIRES DURING REASSEMBLY<br />
1. TRAY BASE<br />
� Hall IC harness is passed through the boss.<br />
� Humid filter harness is passed through the boss, and pasted by the tape, and fixed.<br />
Place for tape to adhere�<br />
Buffalo tape: Width 25 mm, length 50 mm, two tapes<br />
It is put based on the end<br />
face of the projection.<br />
Humid filter harness<br />
Bosses<br />
�<br />
� Ferrite core is inserted in the boss. And turn the Power cord to keep it at the constant length.<br />
Turn three times to adjust the<br />
length of the Power cord<br />
within this extent. Keep<br />
the figuration of power cord<br />
to put it in this span as<br />
indicated.<br />
5 – 19<br />
�<br />
5cm An AC code is put in the boss<br />
from the ferrite core from the<br />
position of 5cm.<br />
Hall IC harness<br />
The AC code winding ferrite<br />
core is inserted between boss.<br />
� The order of the hall IC harness, humid filter harness, AC code is inserted into the lead line exit.<br />
Power code is inserted at the<br />
end to prevent floating of each<br />
harness.<br />
Be careful for wire break of<br />
the Hall IC harness and the<br />
humid filter harness caused<br />
Confirms that a tray base cushion is pasted certainly.<br />
Place for tray base to adhere: An extension line in the end face of the convexity of the tray base.<br />
The wall part of the tray base<br />
Attention<br />
GBDYDA008KKFA<br />
The convex of the tray base<br />
Attention<br />
Attention�There must not be a gap between the tray base cushion and the wall.