RMS with Wizard Tools Configuration and Administration ... - Fujitsu

Object types Introduction
Command Function
hvshut Shuts down RMS on one or more nodes in the configuration.
The base monitor on the local node sends a message to other
online nodes indicating which node or nodes will be shut down.
hvswitch Manually switches control of a user application resource from
one system node to another in the RMS configuration. The
resource being switched must be of type userApplication. The
system node must be of type SysNode.
hvutil Provides general administration interface to RMS. It performs
various resource administration tasks, such as dynamically
setting logging levels, sending a resource Offline, clearing
faulted resources or hung cluster nodes in the Wait state,
setting detector time periods, setting Maintenance Mode, and
so forth.
Table 1: Available CLI commands
2.7 Object types
An object type represents a group of similar resources that are monitored by the
same detector (for example, all disk drives). Using the Wizard Tools, you can
create configuration files that contain objects of various types, each representing
resources or groups of resources to be monitored by RMS. The
supported types are as follows:
● SysNode
● userApplication
● gResource
● controller
● andOp
● orOp
Refer to the chapter “Appendix—Object types” on page 195 for the supported
types, their required attributes, and a brief description of each object.
32 J2UZ-5295-03ENZ0(00)