instruction manual manual de instrucciones - Avanti Products

? PREPARATION1. Connect the water inlet hoseto the water faucet. Don’tswitch on the power if thewater pressure is lower than0.05MPa and higher than0.5MPa.2. Open the water faucet.2.Turn on the water faucet.3. Insert the plug into thesocket. For safety the plugshould have groundconnection.4. Place the drain hose in thecorrect position.5. Open the door and put thewash load into the tubevenly. Then close the door.6. Pull out the detergent drawer and add the wash detergent andsoftener to the corresponding position as following:? For pre-wash detergent? For wash detergent? For softenerWhen using the liquid detergent (recommended for programswithout pre-wash process), insert the detergent cup and followthe instructions on the package.7. Push back the detergentdrawer.WARNING: DO NOT pull out thedetergent drawer while theappliance is in operation becausethis may cause water to spill out.When using the soap powder, remember to remove the liquiddetergent cup.NOTE: DO NOT overflow the deterg ent and softenercompartment.?Warning?When using liquid chlorine bleach you must follow these steps.Failure to follow these directions may result in damaged clothes.1. Insert the load to be washed into the unit2. Turn on the unit to your desired mode.3. Add dete rgent or liquid soap (see page 12 for details).4. Wait for 3 minutes after the washing cycle starts. Then measure the correct amount of liquidchlorine bleach (do not exceed 1/3 cup) otherwise you will damage the clothes.5. Open the drawer and pour the liquid chlorine bleach into center section 2 of drawer12